About EQX Global Group
At EQX Global Group, we believe in sustainable bonding solutions that not only connect businesses but also create a positive impact on people and the planet. Our corporate story is built on the foundation of purpose and our commitment to the Sustainable Development Goals (SDGs) and Environmental, Social, and Governance (ESG) principles.
Contact Us
- PMT 1159, Lorong Perindustrian Bukit Minyak 22, Penang Science Park, Taman Perindustrian Bukit Minyak, 14100 Simpang Ampat, Pulau Pinang, Malaysia
- (604) 5057883, 5057885, 5057886
PROMOSOLV COAT UT10-UV
PROMOSOLV COAT UT10-UV
Coatings Materials Encapsulants Gels And Potting
A transparent hydrophobic and oleophobic ultra-thin coating to protect electronics and other surfaces against moisture, corrosion and other environmental conditions that could jeopardise the rea;iability of the device or surface.
Adheres well to a wide variety of material substrates as plastic, glass, metal and ceramic. This product is formulated with a UV tracer for easy detection under UV light in order to support quality control.
The coating is available with a 2 and 4% solid content, which provides a different dry film thickness.
FEATURES:
- Ultra-thin hydrophobic & oleophobic coating with UV tracer
- Dipping & spray process
- Easy & fast process
LIQUID PROPERTIES:
CHARACTERISTICS | PROMOSOLV COAT UT10-UV 2% | PROMOSOLV COAT UT10-UV 4% |
| Chemical Nature | Fluoropolymer | Fluoropolymer |
| Solids (weight %) | 2 | 4 |
| Appearance | colourless, clear to slightly cloudy | colourless, clear to slightly cloudy |
Density (g/cm3) at 20°C | 1.4 | 1.4 |
| Solvent type | Hydrofluoroether | Hydrofluoroether |
Boiling point of solvent carrier | 61-76°C (142°F-169°F) | 61-76°C (142°F-169°F) |
| Flash point | None | None |
| Viscosity (cST) | ~1 | ~1 |
| Surface tension (mN/m or dynes/cm) | 13,6 | 13,6 |
BENEFITS:
| PERFORMANCE |
|
| COST |
|
| HSE |
|
PROCESS RECOMMENDATION:
The best process will depend on factors such as operating conditions, equipment, time and the cleanliness of the parts.
- Dipping process recommended/spray application possible(especially for selective deposition)
- Typical coating thickness is about 0.2 to 0.5 microns by dipping application
- Recommended to apply on cleaned and dried surfaces
- Touch dry within less than a minute/No thermal or UV cure required
- Visible under UV light (around 350nm) to allow inspection after the coating is applied. The UV tracer will disappear within 1-2 weeks after the coating is applied as it has no function in the protective properties of the coating.
- In order to manage the solid content in the coating bath, Promosolv Coat DILUENT 10 is used to add solvent and Promosolv Coat UT10 8% (no UV tracer needed) is used to add solid content.
- Promosolv Coat DILUENT 10 can also be used to remove coating or for nozzle and equipment cleaning.
No Article Found
